Striproll Sureclad is a roll-formed roof and wall sheeting product made from modern high-tensile Bluescope Steel feed coil and is custom cut to length. Striproll Sureclad covers 762 mm with a rib height of 28 mm.
- BHP Zincalume conforming to Australian standard AS1445-AZ150,
- BHP Colorbond material conforming to AS 1445-AZ150 and AS 2728.
- Galvanized Zinc Hi-Ten G550-Z450.
Fix to current code of practice HB 39-1999. Minimum pitch 3 degrees*. Fasteners available in standard colours. Non standard colours may be subject to longer lead times.
Do not locate fasteners less than 25 mm from ends of sheets. When valley fixed it is recommended to include a side lap fastener to ensure a weather resistant joint.
Fasteners available in standard colours. Non standard colours may be subject to longer lead times. Do not locate fasteners less than 25 mm from ends of sheets.
Recommended screws Timber supports Steel supports
Crest fix (Roofing) 12 x 65 type 17 12 x 45mm self drilling metal
Valley fix (walling) 12 x 25 type 17 10 x 16mm self drilling metal
Delivery,Handling and storage:
Normally delivered to the building site in strapped bundles. If not required for immediate use, sheets or bundles should be neatly stacked clear of the ground and if left in the open, should be protected by loose but secure tarpaulins or similar cover.
On no account should bundles be left exposed to the weather. Rain or condensation are easily drawn in between tightly nested sheets by capillary action, and because of this moisture not being able to evaporate naturally, unsightly stains can be caused which can detract seriously from the finished appearance of the installation.
It is the customer's responsibility to be present or have a representative present, to accept the product in good order and condition upon delivery. The customer is also responsible for unloading their goods.
In the event of an unattended site, our driver will endeavour to unload as close to the site as possible. In these instances Striproll will not accept claims for damages to the product, property or injury caused during unloading, nor claims for pilferage of part or all of the delivery made. Any additional costs will be to the customer's account.
Please specify base metal thickness,colour,sheet length,sheet quantity,delivery or pick up,and date preferred for delivery/pick up
*Minimum pitch of 2.0 degrees for 1%/5 minute IDF rainfall intensity up to 200 mm/h with maximum roof run length of 60 meters.
Minimum pitch of 3.0 degrees for 1%/5 minute IDF rainfall intensity up to 220 mm/h with maximum roof run length of 70 meters.
Steeper pitch slope required for higher location rainfall IDF's and longer roof run lengths. For further information contact the Striproll sales department and referance the product data brochure.